karl_2ltGC
12-05-02, 05:32 PM
i got a few guages(vdo), and it seem the temperature works fine, but not when the ignition is in the ON position(motor on or off makes no diff)
There wired correcty and work fine, but when in the ON position they go to what they should be, then bounce back to there minimum reading then jump back again, this happens avery 1-2 seconds or so, and if its not doing that then it just goes stupid.
Any help much appreciated
Karl
There wired correcty and work fine, but when in the ON position they go to what they should be, then bounce back to there minimum reading then jump back again, this happens avery 1-2 seconds or so, and if its not doing that then it just goes stupid.
Any help much appreciated
Karl