Beavis
18-07-02, 12:50 AM
Guys,
With Kangz' help - well, he did all the work :p - (and, thanks, everyone that replied to my wiring fuel pump thread in General Tech), we finally got the RX-4 going last night. However, we kind of had to bodge it. For some reason, the Wolf3d isn't firing out the "turn on the pumps" signal to the relay. Obviously I'm not using the Wolf to power the pumps, merely to send the signal to the relay to switch the pumps on. I would imagine this is how 99% of ECUs are setup?
Anyway, I'm going to give AEM a call - up `til now they've been super helpful, I'm sure they'll keep it up - to ask them if they've ever heard of this happening, or if it's some bizarre software config or just a simple mistake I've made.
In the meantime, though, has anyone got any suggestions?
Thanks guys,
Chris
With Kangz' help - well, he did all the work :p - (and, thanks, everyone that replied to my wiring fuel pump thread in General Tech), we finally got the RX-4 going last night. However, we kind of had to bodge it. For some reason, the Wolf3d isn't firing out the "turn on the pumps" signal to the relay. Obviously I'm not using the Wolf to power the pumps, merely to send the signal to the relay to switch the pumps on. I would imagine this is how 99% of ECUs are setup?
Anyway, I'm going to give AEM a call - up `til now they've been super helpful, I'm sure they'll keep it up - to ask them if they've ever heard of this happening, or if it's some bizarre software config or just a simple mistake I've made.
In the meantime, though, has anyone got any suggestions?
Thanks guys,
Chris