So i want to completely change up the front suspension on my GT4 Celica.
I have some ideas in mind, but really i need to first 3D model the factory setup so i can then work out the effects of using the Prius up-rights (dont laugh, it looks like they will do the job well), different length LCA's, strut mounting points, etc, etc.
Any tips on how i should accurately measure and model the suspension from the car?
I was thinking of laying a big sheet of paper under the suspension corner, then using a plumb bob to draw the mounting points on that paper, also noting the height of the point off the ground.
Any better suggestions?