Page 2 of 2 FirstFirst 12
Results 31 to 33 of 33

Thread: Uber-noob part fabrication question

  1. #31
    Registered User
    Join Date
    Sep 2013
    Location
    ....................
    Posts
    5,826
    if it were mine i'd use thin ally (1.5/1.6) as it weighs fuck all and with the bends plenty strong enough.

    Ask your fabricator what he has in stock that would be the easiest.
    ......................

  2. #32
    Registered User
    Join Date
    Sep 2013
    Location
    ....................
    Posts
    5,826
    Anyone able to do a proper bend drawing of this for Forg ?

    This basic 2D program i use does not allow it and whilst it is fine if iam bending not so much if he is sending it out to a fabricator.

    can email the DXF.



    ......................

  3. #33
    Non Compos Mentos Gammaboy's Avatar
    Join Date
    Jun 2008
    Location
    Brisbane
    Posts
    15,631
    Can't just annotate 90* Up, 90* down onto it?
    "Where can we get hold of a Vincent Black Shadow?" "Whats that?" "A fantastic bike," I said. "The new model is something like two thousand cubic inches, developing two hundred brake-horsepower at four thousand revolutions per minute on a magnesium frame with two styrofoam seats and a total curb weight of exactly two hundred pounds."

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •