![]() |
|
|
|
#40 |
|
The Dude
Join Date: Apr 2002
Location: Canberra
Posts: 1,130
|
OK so the idea was to create new engine mounts that I feel will work better but also look better.
Heres a pic of the old engine mounts, I got the idea for these ones from Australia Street Rodding and seemed to come out better in that mag then for me. ![]() So for this bit I used 5mm plate that I had laying around, sat down and made a template and came up with this (with the plate marked out) ![]() All the bits cut out and hole drilled ![]() Both Welded up and tacked into place.. ![]() By this time I ran out of cutting disk so I will start on the engine side of the mounts this week some time.
__________________
Growing a Mo for Movember, click here to donate! VS II 50th Anniversary Ute (parts chaser) 32 Ford Hot Rod (chassis only, project on hold for how long?) 28 Inter Pick Up Hot Rod (Current project) |
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HQ HOLDEN PARTS (HQ/HJ/HX) & Assorted Holden Parts | BOOTHY | Cars - General Car Parts For Sale or Wanted | 5 | 30-01-08 09:46 PM |
| Rally 1600 getting hot (Air flow issues) | Burns | General | 15 | 19-03-06 11:50 AM |