RB20 turbo manifold

browny · 31-01-03, 02:15 PM

I'm fitting an RB20 to an EH, i've managed to get the engine in but the compressor housing fouls on the chassis rail by a little bit.

I figure I can...

A. Get a high mount manifold

Can someone tell give me an idea what a high mount manifold would cost?

B. Do something else....

Anyone got any suggestions?

I probably only need the turbo mounted about an inch higher to give some decent clearance and I dont want to cut the chassis rail.

Cheers, Tim

31-01-03, 02:15 PM	#1
browny stupidhead Join Date: Jun 2002 Location: Newcastle Posts: 1,597	RB20 turbo manifold I'm fitting an RB20 to an EH, i've managed to get the engine in but the compressor housing fouls on the chassis rail by a little bit. I figure I can... A. Get a high mount manifold Can someone tell give me an idea what a high mount manifold would cost? B. Do something else.... Anyone got any suggestions? I probably only need the turbo mounted about an inch higher to give some decent clearance and I dont want to cut the chassis rail. Cheers, Tim __________________ Put that in your pipe and smoke it EH Holden RB20 Build

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)